Varme Underfloor Heating
Varme Under Floor Heating Cable Mat Varme Cable Mat

The Varme Cable Mat electric underfloor heating system uses the same high quality cable supplied in the kits, but comes pre-attached to a mesh so it can be simply 'rolled out' for speed of installation in large areas.


Varme Under Floor Heating Loose CableVarme Loose Cable

The Varme cable kit is by far the most popular electric underfloor heating system in small confined areas such as bathrooms, whilst the larger kits offer cost savings against mats of the same size.


Varme Under Floor Heating Carbon Heating Film Varme Carbon Film

Our Carbon Heating Film is ideally suited for installation beneath wood or laminate floors. At less than half a millimeter thick, it has a negligible effect on floor height. The film is laid over our exceptional 6mm Depron Foam insulation (which replaces the standard flooring underlay) to give a minimal effect on your floor height - less than 7mm!


Varme Aluminium Mats

Heating Mat with Aluminium thermal-reflection

Our Ali Mat is an under wood / laminate fully earthed twin-conductor heating mat with a thermal reflective solid aluminium foil.

The heating mat is laid over our exceptional 6mm or 3mm Depron Foam insulation (which replaces the standard flooring underlay) to give minimal efect on your floor height. It has a aluminium reflective surface which improves the thermal reflection properties and efficiency of the system.



Our 'Ali Mat' is ideally suited for installation directly beneath wood or laminate floors. Used primarily in bathroom where a non earthed product such as the carbon heating film is not an option.

The heating mat is available in a wide range of sizes.

Technical data:

Ultra low wattage per linear meter twin‐heating conductor with earth braiding,
attached to solid aluminum foil


Supply voltage: 230 Vac
Max. load per linear meter wire: 6.5 Watt
Wire construction: Stranded resistance wires with
Double insulated and braided
earth shield.
Earth shield: 0,5mm² tinned copper connected
to Aluminum foil
Type of insulation: ETFE/PA
Thickness of mat: 2mm
IP rating: IPx7
Factory testing: 2.5 K volt Dielectric withstand
Applied standard: IEC 60335‐1 / 60335‐2‐96